- This line was added.
- This line was removed.
- Formatting was changed.
To deploy an OnSight vCollector as an image, you need to download the VMware image from the Panopta package server and import the image into a designated hypervisor. vSphere 6.5 and above is required for the host to import the image. The system requirements are detailed here.
To install the OnSight vCollector, perform the following steps:
Download the OnSight image.
After downloading the OnSight image, import it as a virtual machine into your hypervisor. Once your OnSight is imported and booted, the VM will go through the normal Linux startup process, finishing with a login prompt.
Log in with username panopta and password panopta. You will then be prompted to set a new password.
Important note: Do not lose this password. Without it, there is no way to access the OnSight for further updates.
Configure the network by running
sudo onsight configure-networkas root. See Network Configuration for more details.
Register the OnSight by running
sudo onsight register --customer-key <customer-key>as root. Your OnSight appliance key will also be displayed.
where <customer-key> is your own customer key. To obtain your customer key, visit the Control Panel and click your avatar then select My Account.
Proceed through the final steps of the OnSight installation process in the Control Panel, where you can assign things such as the Alert Timeline and Instance Group to use for your new OnSight.
The OnSight will begin syncing immediately after deployment.
By default, the OnSight vCollector will attempt to use DHCP except in AWS, which pre-configures networking correctly. Basic network configuration is available by running:
|Paste code macro|
sudo onsight configure-network
This will walk you through a series of steps that allows you to configure the following:
Select a network interface for the OnSight
Use static IP or DHCP
For complex use cases like bridging multiple networks or custom route configurations, you need to manually configure the network. Please reach out to email@example.com contact our support team if you need assistance.
NTP server configuration
The OnSight uses the default Ubuntu NTP servers for time synchronization. If your environment blocks outbound NTP access, you can configure the OnSight to use an internal NTP server using the following:
|Paste code macro|
sudo onsight configure-ntp
This will request a list of servers to use then update the configuration and restart the NTP daemon to pick up the new servers.
On this page
|Table of Contents|